Filter
Top Products
DMD15/DMD15L IBS/IDR Satellite Modem Operation
TM051 - Rev. 5.8 3-19
For the Transmit Side:
1. Push <ENTER> to get the flashing cursor.
2. Use the Up Arrow Key to make the left portion of the display read “TX EDIT”.
3. Use the Right or Left Arrow Keys to switch the flashing cursor to the right portion
of the display.
4. Use the Up or Down Arrow Key to make the right hand portion read “TX ACTIVE”.
5. The mapping display should now look like this:
Map Copy
TX EDIT > TX ACTIVE
6. Push <ENTER> to enter this command. This tells the modem to configure to the
settings that were assigned in the Channel/Timeslot display.
For the Receive Side:
1. With Rx Side Channels configured as follows: CH1 to TS1, CH2 to TS2, CH3 to
TS3 and CH4 to TS4.
2. After the timeslots are assigned properly, scroll to the Mapping Menu and use the
above procedure to enter the settings into the modem.
3. Set the display to read:
Map Copy
RX EDIT > RX ACTIVE
4. Press <ENTER> to enter the settings into the modem.
To View the current Timeslot Assignment:
1. If there is a question of the channels not being entered properly, the Mapping
Menu may be used to see how the channels/timeslots are configured in the
modem.
2. Use <ENTER> and the Arrow Keys to make the mapping menu read (for the Tx
Side):
Map Copy
TX ACTIVE > TX EDIT
3. Press <ENTER>. The modem has now copied the current Tx Settings to the Tx
Channel/Timeslot Display.
4. For the Rx Side:
Map Copy
RX ACTIVE > RX EDIT