Filter
Top Products
User Interfaces DMD15/DMD15L IBS/IDR Satellite Modem
4-16 TM051 – Rev. 5.8
Remote AUPC (menu): The 'REMOTE AUPC CONFIGURATION' menu contains
the remote configuration parameters for the AUPC
Function.
AUPC Enable: {OFF, ON}
Allows the user to enable or disable the AUPC Function
of the remote modem. The remote AUPC Function is
the response of the local modem to commands for an
increase or decrease of the Transmit Power in 0.5 dB
steps and the command to change to the setting
indicated in the 'REMOTE CL ACTION' menu of the
remote modem upon receiver loss of lock.
Loopback:
Allows the user to enable or disable the Baseband
Loopback Test Mode of the remote modem.
TX 2047 Pattern:
Allows the user to enable or disable the Transmit 2047
Pattern Test Mode of the remote modem.
Remote AUPC Monitor:
The ‘REMOTE AUPC MONITOR’ Menu contains the
remote monitor status for the AUPC Function.
Remote 2047 BER: Reports the BER measurement of the receiver 2047
Pattern Test Mode of the remote modem. BER is
reported from the 1x10
-5
to 1x10
-7
in tenth decade steps.
If the pattern does not synchronize or is out of range,
‘NO DATA’ will be displayed.
4.3.6 Monitor Menu Options and Parameters
Level: Displays the estimated receive signal level as seen by
the Demodulator.
Eb/No: Displays the estimated E
b
/N
o
as seen by the
demodulator.
SER: Displays the estimated channel error rate (before
decoding) measured by the modem.
CBER: Displays the estimated corrected bit error rate (after
decoding).
Error Count: Displays the current error count from the Viterbi
Decoder.
Offset Freq: Displays the received carrier frequency offset as
measured by the modem.