Filter
Top Products
C. Traps and MIBs
6300-A2-GB20-10 November 2003
C-15
applTracerouteTestId
(traceroute 1)
Unique TraceRoute test ID. Contains applNewTestID after Get.
applTracerouteIpAddress
(traceroute 2)
Destination IP address for
TraceRoute test.
Set destination IP address.
applTracerouteSourceIpAddress
(traceroute 3)
Identifies the source IP address. Set source IP address.
applTraceroutePacketSize
(traceroute 4)
Specifies TraceRoute packet size.
Range + 28 bytes of header
information.
28 — 15028 – Range.
64 – Default.
applTracerouteTimeOut
(traceroute 5)
Timeout value in seconds
between echo request attempts.
10 – Default.
applTracerouteMaxHops
(traceroute 6)
Maximum number of hops to be
tested.
8 – Default.
applTracerouteDomain
(traceroute 7)
Specifies the destination IP
address’s service domain.
mgmt(2) – Management Domain.
service(3) – Service Domain. Default.
applTracerouteIfIndex
(traceroute 8)
Specifies the route for the
TraceRoute test.
If the target interface is not specified, the
default will display the calculated ifIndex.
applTracerouteTestOwner
(traceroute 9)
Identifies who started the test. 1 – 40 characters.
applTracerouteTestId
(applTracerouteResultsEntry 1)
Contains the results of a
TraceRoute test.
Supports only one test per device.
applTracerouteHopCount
(applTracerouteResultsEntry 2)
Number of hops to reach the
gateway.
—
applTracerouteResultsIpAddr
(applTracerouteResultsEntry 3)
IP address of the gateway. —
applTracerouteResultsHopCount
(applTracerouteResultsEntry 4)
Number of hops to reach the
gateway.
—
applTracerouteResultsPacketSize
(applTracerouteResultsEntry 5)
Specifies the data size of the
packets (in bytes) sent during the
TraceRoute test.
—
applTracerouteResultsProbe1
(appTracerouteResultsEntry 6)
Displays roundtrip time in 100 ms
intervals of the first probe sent to
the gateway.
0 – Probe has timed out.
applTracerouteResultsProbe2
(applTracerouteResultsEntry 7)
Displays roundtrip time in 100 ms
intervals of the second probe sent
to the gateway.
0 – Probe has timed out.
applTracerouteResultsProbe3
(applTracerouteResultsEntry 8)
Displays roundtrip time in 100 ms
intervals of the third probe sent to
the gateway.
0 – Probe has timed out.
diagTestTrapEnable
(configure 1)
Use to enable or disable
diagApplTestStart and
diagApplTestStop traps.
Bit Sum.
1 – Test Start.
2 – Test Over.
Table C-8. Application Test Group Objects (3 of 3)
Object Description Setting/Contents