Filter
Top Products
A. Command Line Interface
6300-A2-GB20-10 November 2003
A-17
IP Packet Processing Commands
Table A-12. IP Packet Processing Commands
IP multicast {enable | disable}
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables the forwarding of IP multicast packets. This setting is retained across
power cycles.
enable – Enable forwarding of IP multicast packets.
disable – Disable forwarding of IP multicast packets. This is the default setting.
IP routing {enable | disable}
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables routing capability for traffic in the service domain so the device
operates as a router (gateway) or a bridge.
NOTE: IP routing of traffic in the management domain is unaffected by this command;
IP routing is always enabled for management domain traffic.
enable – Enable IP routing for traffic in the service domain; the router operates as a
gateway. If upgrading software to R3, the default is enable so the router’s current
functionality is retained.
disable – Disable IP routing for traffic in the service domain. This is the default setting.
packet processing {enable | disable}
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables the processing of all service domain packets, including IP packets.
This setting is retained across power cycles.
enable – Enable processing of packets. This is the default setting.
disable – Disable processing of packets.