Filter
Top Products
A. Command Line Interface
6300-A2-GB20-10 November 2003
A-21
Telnet Commands
The Telnet commands are only available for the Hotwire 6351 ReachDSL Router.
Table A-14. Telnet Commands (1 of 2)
telnet {enable | disable}
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables service domain Telnet access.
enable – Enable service domain Telnet access to the CLI.
disable – Service domain Telnet access to the CLI is not allowed. Any current service
domain Telnet sessions will not terminate, but no future service domain Telnet connection
attempts will be accepted. This is the default setting.
telnet login {enable | disable}
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables Telnet login and password validation.
enable – Enable login and password validation for the Telnet session connection using
the configured Telnet login ID(s) and password(s).
disable – Login/password validation is not performed for the Telnet session connection.
This is the default setting.
telnet name create {admin | operator} login-id password
Minimum Access Level: Administrator
Command Mode: Config
Provides the capability of configuring up to four login/password/access level combinations
in the service domain from which the ReachDSL Router will accept Telnet connections
when Telnet Login is enabled. To change an access level or login ID, you must first delete
it, then recreate it. To change a password, reenter the create command line with the new
password.
admin – The maximum access level for the log-in/password combination is Administrator.
operator – The maximum access level for the log-in/password combination is Operator.
login-id – An ID of 1–31 alphanumeric characters in the ASCII hex range of 0x21–0x7E.
Invalid characters are #, $, %, and &.
password – A password of 1–31 alphanumeric characters in the ASCII hex range of
0x21–0x7E. Invalid characters are #, $, %, and &.
telnet name delete {admin | operator} login-id
Minimum Access Level: Administrator
Command Mode: Config
Provides the capability of deleting the log-in and password for the service domain Telnet
connection.
admin – The maximum access level for the log-in/password combination is Administrator.
operator – The maximum access level for the log-in/password combination is Operator.
login-id – An ID of 1–31 alphanumeric characters in the ASCII hex range of 0x21–0x7E.
Invalid characters are #, $, %, and &.