Filter
Top Products
A. Command Line Interface
6300-A2-GB20-10 November 2003
A-23
Traps Command
Clearing Statistics Command
Performance statistics can be cleared using the CLI, resetting the statistical counts
to zero.
Table A-15. Traps Command
trap {enable | disable} name of trap
Minimum Access Level: Administrator
Command Mode: Config
Enables or disables the sending of traps. The default is disable.
name of trap:
authen fail – An incorrect login was entered at the console.
ccn – A configuration change has occurred (configuration change notification).
devfail – The router has detected an internal failure.
link up – The Ethernet link is up and operational.
link down – The Ethernet link is down.
selftest – A failure occurred during a restart.
test start – A test has started on the interface.
test stop – A test has completed on the interface.
warmstart – Power-on reset has taken place.
For additional information, refer to Appendix C, Traps and MIBs.
Table A-16. Clearing Statistics Command
clear statistics [ eth1 | dsl1 | ip | bridge | pppoe | tftp ]
Minimum Access Level: Administrator
Command Mode: Standard
Clears the specified set of statistics. If no set of statistics is entered, ALL statistics for the
router are cleared.
Example: clear statistics eth1
eth1
– Ethernet interface statistics.
dsl1 – DSL interface statistics.
ip
– IP processing statistics.
bridge – Bridge statistics.
pppoe – PPPoE statistics.
tftp – TFTP statistics.