Filter
Top Products
Chapter 2: Installing the PowerStation Installing the PA PowerStation
PA PowerStation User Guide 2-7
Installing the PA PowerStation
Once you have prepared the location for your PowerStation, you are ready
to install the unit. To do so, you need to mount the PowerStation to your
enclosure using screws and metal clamps in what is called a bracket
assembly. The bracket assembly contains a mounting clamp with “feet”
and a screw.
The number of clamps depends on the PA PowerStation model. The shape
of the prongs at the bottom of each clamp also depends on the model. The
5”, 6”, and 8” models use a T-shape clamp, and the 10” and 15” models
use an L-shape clamp.
The mounting clamps secure to the PowerStation using a sliding
mechanism. You must slide the feet of the mounting clamp into the
appropriate slot on the PowerStation.
For your convenience, all necessary mounting hardware is included with
the unit.
Mounting the PA PowerStation
Complete the instructions below:
1 Slide the PowerStation into the cutout from the front.
2 Attach the 4-8 mounting clamps, with their screws to the back of the
unit in the spaces provided.
The clamps secure to the unit using the sliding mechanism shown in
Figure 2-1 for 5”, 6” and 8” units or Figure 2-2 for 10” and 15” units.
Figure 2-1: Sliding Mechanism for the 5”, 6”, and 8” PA PowerStations
Figure 2-2: Sliding Mechanism for the 10” and 15” PA PowerStations