Filter
Top Products
Hardware installation 23
Model 3201 G.SHDSL Integrated Access Device User Guide 3 • Quick Start Installation
7. A message will display, “Login Successful.” By typing the character “?”, all the commands will be dis-
played. Any command’s parameters may be seen by entering the command followed by a space and a ques-
tion mark.
→
ethernet ?
[The following parameters appear]
add
delete
set
show
list
clear
IP address Quick Start modification
The first parameter to change is the IP address from the default IP address of 192.168.200.10 (for the CP
units) or 192.168.200.11 (for CO units) to your selected IP address. Follow these steps. Comments are in
brackets […].
→
ip list interfaces <enter>
[lists the characteristics of the different interfaces]
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
-------|---------------|------------------|-------------|------------------
1 | ip1 | 192.168.200.10 | disabled | <bridge>
---------------------------------------------------------------------------
→
ip set interface ip1 ipaddress 10.10.10.5 255.255.255.0
[Sets the new IP address which you have selected. The IP
address in this example is for illustrative purposes only.]
→
ip list interfaces <enter>
[To see if the change in IP address is correct]
→
system config save <enter>
[To save the new IP address in flash memory.]
Wait for configuration saved message
Saving configuration
→
Configuration saved.
<enter>
→
The IP address has now been successfully changed.