Filter
Top Products
Installation & Setup 2-5
10. Insert the horizontal shaft (with two different diameters) into the
mounting block as shown. Insert the set screws into the top of the
mounting block. Align the flat on the shaft with the set screws in the
mounting block.
For knife printers, the shaft should be flush with the left edge of the
mounting block.
For non-knife printers, insert the shaft so the step in the shaft is flush
with the right edge of the mounting block.
Note: Securely tighten ALL the set screws in the shaft and
mounting block with a 3/32 Hex key.
11. Look at the stand from above. Adjust the stand so the horizontal
shaft is parallel (aligned) with the front edge of the base plate.
Securely tighten the three screws attaching the stand to the base
plate.
Knife Setup Non-Knife Setup