Filter
Top Products
5-4 Operating Instructions
Setting the Mode
You can select the verifier mode (2 or 19) or use a custom configuration.
Use the Verifier Configuration Tool to create a custom verifier
configuration.
Mode 2 (Def 2) specifies nine different parameters to verify: ANSI
defects, decodability, and grade; quiet zones; partial decodes, decode
errors, passing percent decode; minimum number of I2of5 digits; and no
read.
Mode 19 (Def 19) specifies all parameters from Mode 2, plus contrast
grade, wide to narrow ratio, and minimum and maximum X-dimensions.
Check with your System Administrator on which mode to use.
To change the setting, from the Main Menu, select Setup, then Verifier.
Then follow these steps.
1. Press or until you see
VERIFIER
Mode
2. Press Enter/Pause. The current setting is displayed, for example:
Select Config
Def 2
3. Press or to see the other options. After you display the option
you want, press Enter/Pause.
Are you sure?
No
4. Select Yes or No. If you select “Yes,” the file is sent immediately to
the verifier. This configuration is active for all formats until another
verifier configuration packet is specified. See “Defining the Verifier
Field” or “Defining the Verifier Configuration Packet” for more
information.
5. Press Escape/Clear until you see the Main Menu.