Filter
Top Products
10. Hold the printhead assembly by the printhead tab while
pressing down on the printhead release.
11. Close the printhead by pressing down on the thumb well until
you hear it click into place.
12. Close the cover.
13. Press Feed/Cut to position the supply under the printhead.
If the printer will be unused for extended periods of time, we
recommend leaving the printhead unlatched.
Adjusting the Wide/Narrow Knobs
You may need to adjust the two wide/narrow knobs according to
the width of your supply. For supply that is more than two inches,
adjust the knobs to the wide setting. For supply that is two inches
or less, adjust the knobs to the narrow setting. For linerless
supply, use the narrow setting (knobs are up). For string tag
supply, use the wide setting (knobs are down).
You must adjust both of
the knobs to the same
position.
If you experience ribbon
smudging in cold, dry
environments, adjust the
wide/narrow knobs to the
wide setting.
For wide supplies, push
down and turn the
wide/narrow knobs
clockwise with a
screwdriver.
For narrow supplies, turn the wide/narrow knobs
counter-clockwise with a screwdriver until it pops back up.
The adjustment is shown in the wide position.
2-16
Loading Supplies