Filter
Top Products
To exit an option without changing the setting, press
Escape/Clear.
Supply Type
You can print on aperture, black mark, die cut, or continuous
supplies. You have to tell the printer which supplies you are
using.
If you are using edge aperture supplies, use
the die cut setting. If you are using center
aperture supplies, use the aperture setting.
To change the setting, from the Main Menu, select Setup, then
Supply. If password protection in enabled, press Feed/Cut three
times, then press Enter/Pause before you see the Setup Menu
options. Then, follow these steps.
1. Press l or r until you see
SUPPLY
l Supply Type r
2. Press Enter/Pause to set the supply type option. The current
setting is displayed, for example:
SUPPLY TYPE
l Black Mark r
3. Press l or r to see the other options. After you display the
option you want, press Enter/Pause. Press Escape/Clear
until you see the Main Menu.
4-2
Setting Supply Options