Filter
Top Products
Charging the Handles
This procedure tells you how to charge the handle using the
wall charger.
When using the wall charger or storing it:
• Do not wrap the cord around the transformer.
• Do not pull or put unusual stress on the cord.
To recharge the handle while it is on the printer, push
the power switch off. Do not use the printer while the
handle is charging on the unit.
1. Plug the cord of the wall charger into the handle socket
(Figure 1).
2. Plug the other end of the cord into a 115V electrical outlet.
A full charge takes approximately 8
hours
. The handle
cannot be damaged by overcharging. Therefore, you can
leave charged handle plugged in when not in use.
Areas using 220V, 230V, or 240V will receive a
wall charger designed for these voltages.
WARNING
Inspect the cord for bare wire
before
each use of the wall
charger. Do not use the charger with bare wire.
Handle
(Power Module)
Figure 1
Operator’s Handbook
6