Filter
Top Products
3. Place the roll of supplies between the hubs. Rotate the
dust cover forward
slightly
, so the hubs lock into the core
of the roll. Make sure the supply turns freely on the hubs.
4. Hold the printer upright. In one quick release action, slide
both latch buttons, one on each side of the printer, to the
rear (Figure 4). The platen carrier will
partially
open.
5. Feed the label strip into the printer until it comes out the
front and over the metal roller.
6. Close the dust cover completely.
Feed Label
Strip Here
Platen
Carrier
Guides
Metal
Roller
Latch
Button
Figure 4
2. Getting Started
9