Filter
Top Products
Configuring IP Protocol
100 Perle 833IS User Guide
The IP Pool screen is as follows:
IP Address
The IP address field specifies the base address of a range of IP addresses.The count
field specifies the number of addresses to be added, starting at the base.
To add IP addresses to the IP pool, enter the address in the IP Address field and
count and click Add.
The address must be in the range xxx.xxx.xxx.001 through xxx.xxx.xxx.254. You
must ensure that the IP addresses conform to the subnet mask set for the Internal
WAN Network..
A maximum of 16 IP Addresses can be added.
Count
Specifies the number of addresses to be added, starting at the base address. If no
count is specified, a count of one will be used. If the count would cause an illegal IP
address to be generated (exceeding xxx.xxx.xxx.254), the count will be reduced to
ensure that it is legal.
IP Pool display
Displays the base address and count for the IP Pool entries.
To remove IP addresses from the pool, highlight the entry in the IP Pool display and
click Remove.