Filter
Top Products
17
7. Operation
Remote Control Operation
Remote Control Operation
Basic operation and preparation of the remote control are provided in the ProntoNEO RU 930 User Guide. Read the manual
thoroughly for proper operation. Make sure to install the batteries into the remote control before use.
Operation
1. Press the Device Button to show the Device Overview screen.
2. Tap Proj. PXG 30 to go into the Projector Menu.
3. Main Menu (1st page) will be displayed. Select a menu page by using Page up / down buttons or directly tap the soft buttons
(lens, feature and mouse) on the LCD touch screen. Regarding the name and function of each button, refer to page10 and 11.
Changing the Remote Control Codeset
Eight selectable codes are provided for the remote control (code 1
~ code 8). Code 1 is set by default.
1. Press and hold the Mode button for 3 seconds when the
Projector Menu is displayed. The Mode screen will appear.
2. Tap Brand on the Mode screen. An instruction screen appears
indicating you can set the projector's codeset.
3. Tap Next to define your projector's codeset. The code set
screen appears.
4. Enter the Codeset No. from the right table and press OK to
complete the setting.
– If the codeset is correct, you will hear a confirmation beep.
– If you enter an incorrect code number, you will hear an error
beep and an error message screen will appear. In this case,
press OK and look up the correct codeset number. Then repeat
this procedure.
✽ To get back to the Projector Menu, tap Use button on the mode
screen.
code 1
code 2
code 7
code 6
code 5
code 8
code 3
code 4
codeset 9377
codeset 9384
codeset 9383
codeset 9382
codeset 9381
codeset 9380
codeset 9379
codeset 9378
16.4’
(5 m)
60°
16.4’
(5 m)
60°
Operating Range
Point the remote control toward the
projector (IR sensors) when pressing any
button. Maximum operating range for the
remote control is about 16.4’ (5m) and
60° in front and rear of the projector.
Note:
Codeset of the remote control must be conformed
with that of the projector. Accordingly, if you
change the codeset of either of the two, you also
need to change that of another. (See page 37)
Mode
OK
*Press Use to get back to
the Projector Menu.
Projector
codeset
Remote control
codeset