Filter
Top Products
supports before you purchase a CD-ROM disc that includes compressed audio.
What should I do if the CD-ROM Changer always inserts the first
or the same disc, no matter which disc the software has been
instructed to use?
The software package was probably written to work with a single CD-ROM
Drive. Try placing the disc in the first slot and then reinstall the application.
Contact the software manufacturer to see if a version of the software exists that
supports multiple subunits.
If you are using an ASPI compatible host adapter, the ASPI Manager may require
an /L: or /ET: statement to enable access to multiple logical units. Refer to the
documentation accompanying the host adapter or contact the host adapater
manufacturer..
What should I do if the BUSY light flashes at one second
intervals and the drive does not respond to commands?
This is a visual indicator from the drive that something is affecting the CD-ROM
Changer’s ability to perform. It may be a mechanical problem. Or, the drive may
be in Test Mode. Make sure the switch for Test Mode is DOWN/OFF. For almost
all DOS applications, only the terminator switch (SW #2) on the DRM-602X
should be up. All others on the DRM-602X and all switches on the DRM-604X
should be down.
What should I do if the Magazine will not eject from the unit?
There are two possible causes of this symptom. One is that the software has
locked the magazine into the machine and will not let the user eject the disk. The
other is that the user has set the last dip switch UP/ON so it has disabled the eject
switch on the front panel. In either case, to remove the magazine, make sure that
the last dip switch is DOWN. Then turn the Pioneer CD-ROM Changer OFF and
back ON. This should allow the front panel eject button to work.
NOTE: If the magazine still does not eject, call End-User CD-ROM Technical
Support. See Appendix F for Pioneer Technical Resource Numbers.
Questions and Answers Chapter 6
6-2 Software Driver Installation Guide / Owner’s Manual