Filter
Top Products
Troubleshooting IBM- PC DOS / WINDOWS Installation Appendix A
A-10 Software Driver Installation Guide / Owner’s Manual
Cartridge will not
eject from the
Changer
1. There are two possible causes of this symptom. One is that the
software has locked the magazine into the machine and will not let the user
eject it. The other is that the user has set the last DIP switch UP/ON so it
has disabled the EJECT button on the front panel.
2. In either case, to remove the magazine, make sure the last DIP
switch is DOWN, then turn the Pioneer Changer OFF and back ON. This
should allow the front panel EJECT button to work. NOTE: The DRM-602X
provides a light on the front panel of the unit that indicates if the EJECT
button is disabled, locking the magazine.
1. Use the most current version of the driver. Current Pioneer CD-ROM
Changer drivers are available on the Pioneer Electronic Bulletin Board.
See Appendix E, Pioneer Technical Resource Numbers
3. If a disc tray is stuck, refusing to allow the magazine to eject,
contact Pioneer Technical Support or Pioneer Service.
The drive always inserts
the first or the same disc,
no matter which disc the
software has been
instructed to use
3. The software package was probably written to work with a single
CD-ROM. Try placing the disc in the first slot and then re-install the
application. If this works, contact the software manufacturer to see if a
version of the software exists that supports multiple sub-units.
2. Contact ASPI interface card manufacturer for information about ASPI
Manager Switches. The ASPI Manager may require /L: statement or /ET:
statement to enable a number of logical units.