Filter
Top Products
Appendix D
(CDP) CD Player Commands
Owner’s Manual / Software Driver Installation Guide
D-1
Using CDP Commands / CDP Command List
For Pioneer CD-ROM Changers
Sending CDP (CD Player) Commands from DOS
:
At the DOS prompt, type the following:
C:\>ECHO 1KL>CDP <CR> (Carriage return or enter)
This will send a command to the CD-ROM Changer to put Key Lock ON, so that
the Magazine cannot be ejected. 0KL will turn Key Lock OFF. See complete list
of CDP Commands starting on page D-2. Any of the CDP Commands can be
used in place of the 1KL in the above set of instructions.
Use the Multi-Player Control Program (MPC) described in Chapter Three,
page 3-16 to send CDP commands to the CD-ROM Changer.
CDP (CD-Player ) Control Commands
Player Commands
Addressing Modes
Block MMSSFF Specifies Minutes, Seconds, and Frames.
Index I I Specifies pre-mastered indices
Time MMSS Specifies Minutes and Seconds (Frame 0)
Track TT Specifies the beginning of track TT
Player Modes
P00 Home No disc is loaded. Magazine inserted.
P01 Park The disc is loaded, but not spinning.
P03 Stop
P04 Play The drive is playing audio.
P06 Pause The disc is spinning, but audio play pauses.