Filter
Top Products
Appendix A
Troubleshooting IBM- PC DOS / WINDOWS Installation
Owner’s Manual / Software Driver Installation Guide
A-1
Troubleshooting IBM-PC DOS/WINDOWS Installation
If the Pioneer CD-ROM Changer does not respond after running through the
Operations Check on page 3-7 of this Software Installation Guide, note any error
messages that may appear in the Inquiry ID line on boot up.
Error messages and how to correct them are described on individual pages of this
Appendix as indicated below. If you do need to call for Pioneer End-User
CD-ROM Technical Support (See Appendix E for Pioneer Technical Resource
Numbers), please be prepared to describe any error messages and the contents of
the CONFIG.SYS and AUTOEXEC.BAT files in your system. This will help
Pioneer Industrial Representatives solve your problem more quickly.
1. Driver Error Messages page #
• SCSI interface card can’t communicate with drive.........................................A-2
• Timeout during selection phase.......................................................................A-4
• Timeout waiting for initial bus free phase
status phase or data phase ............................................................................A-5
• Characters on the Inquiry “ID=0” line are jumbled........................................A-5
• The “Inquiry ID=0 Pioneer CD-ROM DRM-xxxX” line is blank..................A-6
2. MSCDEX Error Messages
• CDR101 Not Ready Reading Drive D............................................................A-7
• CDR 103 Disk is not ISO 9660 or High Sierra...............................................A-8
• Device Driver Not Found................................................................................A-8
• Incorrect DOS Version....................................................................................A-9
3. DOS Error Message
• Invalid Drive Specification .............................................................................A-9
4. Hardware Issues. What to do if.......
• The cartridge will not eject from the Minichanger .......................................A-10
• The drive always inserts the first or the same disc, no matter
which disc the software has been instructed to use....................................A-10
• The BUSY light flashes at one-second intervals and the drive
does not respond to commands ..................................................................A-11
• Boot problems or the unit only accesses Drive D.........................................A-11