Filter
Top Products
IP DSLAM
123
diffdelaytolupstrm
<diffdelaytolupstrm-val>
The maximum differential delay among member links in a bonding group in
Upstream direction. Type: Create － Optional
Modify － Optional
Valid values: 0 -4
Default value: 4
diffdelaytoldnstrm
<diffdelaytoldnstrm-val>
The maximum differential delay among member links in a bonding group in
downstream direction. Type: Create － Optional
Modify － Optional
Valid values: 0 -24
Default value: 4
asmprotocol Enable
|Disable
This parameter specifies whether Autonomous Status Messages will be
exchanged between CO and CPE. If it is disabled then the group would be
bonded statically and CO would assume CPE to know all the configuration
parameters like SID format, number of links in the bonded group and the
links participating in bonding. If it is enabled then CO would inform all these
parameters to CPE using Autonomous Status Messages.
Type: Create － Optional
Modify － Optional
Default value: enable
sidformat EightBitSid
|TwelveBitSid
SID Format: 8 bit or 12 bit SID. Only 8 bit format is being supported
Type: Create － Optional
Modify － Optional
Default value: 1
maxrxbitrateratio
<maxrxbitrateratio-val>
The maximum bit rate ratio among member links in a bonding group in
upstream direction.
Type: Create － Optional
Modify － Optional
Valid values: 1 -4
Default value: 4
linkhecthrshld
<linkhecthrshld-val>
HEC Error percentage of the link upstream rate which will act as Threshold
for link to be part of group in Rx direction
Type: Create － Optional
Modify － Optional
Valid values: 1 -10
Default value: 2
numoflinksupforgrpup
One | All
This field specifies the number of links required to be up for bonding to start
ASM protocol
Type: Create － Optional
Modify － Optional
Default value: 0