Filter
Top Products
IDL series User Guide
620
Type: Modify － Optional
Valid values: 1 -8
maxmulticast
<maxmulticast-val>
Maximum number of multicast groups that can be
configured in the system
Type: Modify － Optional
Valid values: 1 - 4
maxmac <maxmac-val>
Maximum number of MAC addresses that can be learned by
the system. This should be a multiple of 32
Type: Modify － Optional
Valid values: 1 - 4000
maxhashbuck
<maxhashbuck-val>
Maximum number of hash buckets for the Forwarding table.
This value should be a power of 2. (1, 2, 4, 8 ,...)
Type: Modify － Optional
Valid values: 1 - 8192
maxnumvlan
<maxnumvlan-val>
Maximum number of VLANs that can be configured on the
Bridge either statically or dynamically
Type: Modify － Optional
Valid values: 0 - 512
maxvlanidval
<maxvlanidval-val>
Maximum value of VLAN ID that this Bridge can support
Type: Modify － Optional
Valid values: 1 - 4095
maxnumacentry
<maxnumacentry-val>
Maximum number of Static UCast Entries that can be
configured on the Bridge
Type: Modify － Optional
Valid values: 0 - 512
devcap IVL | SVL | none
Device Capabilities of Q-Bridge MIB. In case of Stacked
Vlan Mode this shall apply to Virtual Vlans. Type: Modify －
Optional
bridgingmode Restricted
|Unrestricted |
Residential
This specifies the state of full bridging on the bridge. Value
residential species that packets coming from CPE side
would be forwarded to the net side port without a lookup. In
case of restricted bridging, the packets would undergo a
lookup and if the destination is another CPE port, the packet
would be dropped, i.e. CPE to CPE traffic is not allowed.
Unrestricted bridging is forwarding based on lookup in all
cases.
Type: Modify － Optional
maxhpriotreenodes
<maxhpriotreenodes-val>
Maximum number of classifier tree nodes of high access
priority that can be created.
Type: Modify － Optional