Filter
Top Products
IDL series User Guide
138
interface as the management vlan id. In case the management vlan
(virtual vlan mapped to S-VLAN and C-VLAN for the frame) doesn't
exist (ie. Virtual vlan mapped to 'mgmtsvlanid' or the associated '
psvlanid ', if 'mgmtsvlanid' is zero) on the system then IP based
management shall not happen on the interface till the corresponding
virtual-VLAN is created with the Net side port as its member.
Tagged Mgmt PDU Prio
Priority to be set in Tagged Ethernet PDUs sent on Management
VLAN over this interface. This field is valid only if either 'ip' field is
non-zero or 'usedhcp' field is true. In Native Vlan mode this priority
shall be used for C-Vlan tag while in stacked vlan mode it shall be
used for S-Vlan tag.
Oper Status
The actual/current state of the interface. It can be either up or down.
Admin Status
The desired state of the interface. It may be either Up or Down.
Cautions:
z If an aggregator interface is being created, all configurations of aggregated
links (layer2 Ethernet interfaces), should be same.
5.4.3 LACP Aggr Commands
5.4.3.1 Get lacp aggr
Description:
Use this command to get.
Command Syntax:
gets lacp aggr [aggrifname <aggrifname-val >]
5.4.3.2 Create lacp aggr
Description:
Use this command to create.
Command Syntax:
create lacp aggr aggrifname <aggrifname-val> [actorsystemprio
<actorsystemprio-val>] [actoradminkey <actoradminkey-val>]
[collectormaxdelay <collectormaxdelay-val>] [aggrtype Static | Lacp]