Filter
Top Products
IP DSLAM
283
atuctargetsnr
<atuctargetsnr-val>
Configured Target Signal/Noise Margin. This is the Noise Margin the
modem must achieve with a BER of 10 to the power -7, or better, to
successfully complete initialization.
Type: Modify -- Optional
Valid values: 0 - 310
atucmaxsnrmargin
<atucmaxsnrmargin-val>
Configured Maximum acceptable Signal/Noise Margin. If the Noise
Margin is above this, the modem hould attempt to reduce its power
output to optimize its operation.
Type: Modify -- Optional
Valid values: 0 - 310
atucgsrsintcorrectionup
125us | 250us | 500us | 1ms |
2ms | 4ms | disable
Sets the correction time for the upstream interleaved buffer. RS can
also be disabled.
Type: Modify -- Optional
atucdnshiftsnrmargin
<atucdnshiftsnrmargin-val>
Configured Signal/Noise Margin for rate downshift. If the noise margin
falls below this level, the modem should attempt to decrease its
transmit rate. In the case that RADSL mode is not present, the value
will be 0.
Type: Modify -- Optional
Valid values: 0 - 310
atucupshiftsnrmargin
<atucupshiftsnrmargin-val>
Configured Signal/Noise Margin for rate upshift. If the noise margin
rises above this level, the modem should attempt to increase its
transmit rate. In thecase that RADSL is not present, the value will be 0.
Type: Modify -- Optional
Valid values: 0 - 310
atucminupshifttime
<atucminupshifttime-val>
Minimum time that the current margin is above UpshiftSnrMgn before
an upshift occurs. In the case that RADSL is not present, the value will
be 0.
Type: Modify -- Optional
Valid values: 0 - 16383
atucmindnshifttime
<atucmindnshifttime-val>
Minimum time that the current margin is above UpshiftSnrMgn before
an upshift occurs. In the case that RADSL is not present, the value will
be 0.
Type: Modify -- Optional
Valid values: 0 - 16383
atucfastmintxrate
<atucfastmintxrate-val>
Configured Minimum Transmit rate for 'Fast' channels, in bps. Also
refer to 'adslAtucConfRateChanRatio' for information regarding RADSL
mode and refer to ATU-R transmit rate for ATU-C receive rates.
Type: Modify -- Optional
Valid values: 0 - 0xffffffff
atucintlmintxrate
Configured Minimum Transmit rate for 'Interleave' channels, in bps.