Filter
Top Products
IDL series User Guide
298
GsExpandedExchange
T1.413 parameter that Enables/Disables EES
GsEscapeFastRetrain
This parameter enables/disables escape to the fast retrain
capability
GsFastRetrain
This parameter enables/disables the fast retrain capability.
Currently supported only in G.lite mode.
GsBitSwap
This parameter enables/disables bit swapping
GsNtr
This parameter enables/disables NTR on a per chip basis
GsAlctlUsVer
For T1.413 demo purposes only
GsUseCustomBin
This parameter enables/disables user selection which of the 511
bins will be enabled for upstream and downstream transmission.
GsFullRetrain
Indicates enable/disable of auto retrain capability
GsPsdMaskType
This parameter selects the PSD mask option to be used
GsEraseProfiles
This parameter enables/disables the ability to erase all fast retrain
profiles at startup
GsExtRsMemory
Indicates whether customer's Hardware uses external RS RAM
ParamHybridLossTestStart
Start bin for range of bins to be measured. The default value
mentioned is an indicative value only, for exact value refer to
document number DO-400523-AN and DO-401163-AN.
GsParamHybridLossTestEnd
End bin for range of bins to be measured.
GsDmtTrellis
This parameter enables/disables trellis coding. Trellis coding
should always be enabled for its clear performance advantage.
GslTriggerMode
The type of event that triggers a fast retrain
Type
This object is used to configure the ADSL physical line mode.
GsDnBinUsage
'1' in bit position indicates usage of corresponding bin,whereas a
'0' disables usage of corresponding bin.
ParametricTestInputFile
Indicates Name of the Input file from which to take the Mask Array
Size, lower and upper mask Array. Null string means no file is
specified
Data Boost
Conexant parameter that enables/disables DataBoost option.
Upstream PSD
Conexant parameter that sets the upstream PSD to be either
extended or standard. Used for GSpan Plus only.
Conf PM Mode
PM-related parameter used by the ATU-C to set the allowed link
states. Both bit values can be given simultaneously in the input.
Additional value to disable pmmode is disable, which is equal to 0.
Conf PML0 Time(sec)
PM configuration parameter, related to the L2 low power state.
This parameter represents the minimum time (in seconds)
between an exit from the L2 state and the next entry into the L2
state. It ranges from 0 to 255 seconds.
Conf PML2 Time(sec)
PM configuration parameter, related to the L2 low power state.
This parameter represents the minimum time (in seconds)