Filter
Top Products
E – 11
Preparing the Remote Control
Inserting the Batteries
When using the remote control for the first time, install the batteries that were supplied.
When replacing batteries, purchase two of the same type of AA battery.
Press and at the same time lift
the battery case cover at the
rear of the remote control to
remove it.
1
Follow the markings on the inside
of the case and insert the batter-
ies in the correct plus (+) and mi-
nus (-) directions.
2
First insert the tabs of the battery
case cover, then press it closed.
3
Tabs
Remote Control Range
Point the remote control toward the remote control sensor located at the rear of the main unit and operate.
The range over which the main unit will receive the remote control signal is roughly as follows: within 20° above and 20° below a
line perpendicular with respect to the sensor and within 40° to the left and 40° to the right. The transmission range is about 7 m /
23.0 feet.
Remote control
sensor
Remote control transmitter
Approximately 7 m / 23.0 feet
Note:
* Exposure of the main unit's remote control sensor or the remote control transmitter to bright light or the obstruction of the signal by an obstacle located in the
pathway may prevent operation.
* The remote control will not function when the batteries are exhausted.