Filter
Top Products
E – 7
Names of the Main Unit Parts
PO
W
ER
O
N
O
FF
P
O
W
E
R
/
S
T
A
T
U
S
O
N
/
S
T
A
N
D
B
Y
A
S
P
E
C
T
S
O
U
R
C
E
Ventilation outflow holes
These ventilation outflow holes used for cooling
the main unit and discharge the heat of the lamp.
Attention!
Pay special attention to the ventilation outflow
holes. The heat from the lamp is discharged
from the ventilation outflow holes.
Remote control sensor
The remote control signal is received
here.
→
Page E-11
Air intake hole
This is an air intake hole used for
cooling the main unit.
Air intake hole
AC IN connector
The supplied power cable is
connected here.
→
Page E-16
POWER switch
This is the main power
switch.
→
Page E-16
POWER
/
STATUS
ON/STANDBY
ASPECT
SOURCE
POWER/ (STANDBY) indicator
On and Standby operation modes are indicated when this
indicator is flashing green or lit orange. The indicator is not lit
when the POWER switch is "off."
→
Page E-21
ASPECT button
This button selects the aspect ratio (i.e., the ratio of
screen width and height) of the input video.
→
Page E-23
SOURCE button
This button selects the input sugnal of the main unit
that will be used for the connections .
→
Page E-23
ZOOM ring
This adjusts the size of the projected picture.
→
Page E-22
STATUS indicator
Lit/flashing serve to indicate the main unit temperature,
lamp, lamp cover, lamp cartridge, and fan conditions.
→
Page E-45
ON/STANDBY button
This button is used to switch ON the power and set the unit
to the STANDBY mode.
→
Page E-21
FOCUS ring
This adjusts the focus of the projected picture.
→
Page E-22