Filter
Top Products
E – 8
Names of the Main Unit Parts
O
N
/
S
T
A
N
D
B
Y
A
S
P
E
C
T
S
O
U
R
C
E
P
O
W
E
R
/
S
T
A
T
U
S
DVI-D RGB
S-VIDEO
VIDEO
Y
Pb/Cb
Pr/Cr
Theft prevention locking hole
(See below)
Air intake hole
This is an air intake hole used for cooling the main unit.
Ventilation outflow hole
This ventilation outflow hole is used for cooling the
main unit and discharges the heat of the lamp.
DVI-D RGB
S-VIDEO
VIDEO
Y
Pb/Cb
Pr/Cr
S-VIDEO connector
This is connected with the S-VIDEO output connector of the
equipment to be connected.
→
Page E-17
DVI-D connector
This is connected with the (24-pin) DVI-D output
connector of the equipment to be connected.
→
Page E-19
RGB Connector
This is connected with the RGB output connector (mini D-Sub
15 pin) of the equipment to be connected.
→
Page E-17
YPbPr/YCbCr Connector
This is connected with the YPbPr output connector or YCbCr output
connector of the equipment to be connected.
→
Page E-18
CTRL connector
This connector is for service personnel only.
(A seal is applied prior to shipping from the factory.)
End users should not use this connector. Doing so by
end users may cause breakdown.
Theft Prevention Lock
The theft prevention lock is supported by the Micro Saver
Security System manufactured by Kensington Technology
Group.
VIDEO connector
This is connected with the VIDEO output connector
of the equipment to be connected.
→
Page E-17