Filter
Top Products
E – 9
Names of the Main Unit Parts
Attaching the Supplied Adjusters
The supplied adjusters are required for vertical adjustment of the projector.
See → Page E-22 about "Using the Adjusters"
1. Remove a rubber pad of each front foot.
Note: The rubber pads are bonded. Being carful not to mar the plastic
part of the front feet, remove the rubber pads.
2. After putting projections on the back of the supplied adjuster into
depressions of the front feet, tighten the screws.
Front adjuster
These feet are used for height
adjustment.
→
(See below)
Rear adjuster
These feet are used for height
adjustment.
→
Page E-22
Lamp cover
This cover is removed when replacing the lamp
cartridge of the light source.
→
Page E-46