Filter
Top Products
ConnectUPS Web/SNMP Card (X and BD Models) User’s Guide : Rev A www.powerware.com
5
CHAPTER 2
INSTALLATION
With the hot-swappable feature, the ConnectUPS Web/SNMP
Card can be installed easily without turning off the UPS or
disconnecting the load.
To install the ConnectUPS Web/SNMP Card, perform the
following steps:
1. Verify that both DIP switches on the card are set to
the
0 (off) position.
2. Remove the X-Slot or BestDock cover on the UPS rear
panel. Retain the screws.
NOTE If there is another card already installed with an attached
communication cable, disconnect the cable and then remove the card.
3. To prevent electrostatic discharge (ESD), place one
hand on a metal surface such as the UPS rear panel.
Slide the ConnectUPS Web/SNMP Card into the open
slot and secure with the screws removed in Step 2.
1
0
4. Connect an active 10/100BaseT cable to the Uplink
Ethernet connector on the ConnectUPS-X or to the
network connector on the ConnectUPS-BD.
NOTE Three additional 10/100 Mb Ethernet connectors are available on
the ConnectUPS-X and are served by an internal switching hub. If you
frequently move devices between these connectors or make configuration
changes, it may be necessary to clear the cache by pressing the Reset
button on the card front panel.