Filter
Top Products
ConnectUPS Web/SNMP Card (X and BD Models) User’s Guide : Rev A www.powerware.com
9
CHAPTER 3
LOCAL CONFIGURATION
Use the following procedure to access the card’s configuration
program through a serial port.
Before You Start
To use the configuration program for the card, you need:
:
The serial cable included with the card.
:
A terminal with a serial communication port, or a computer
with a terminal emulation program such as HyperTerminal
The serial line should be set to 9600 baud, No parity, 8 data
bits, 1 stop bit, and no flow control.
Connecting the Card
To connect the card to the terminal or computer and start the
configuration program:
1. Plug the serial cable into the COM port on the
ConnectUPS Web/SNMP Card.
2. Plug the other end of the serial cable into the TTY
port on the terminal or the COM port on your
computer.
To TTY port on terminal
or COM port on computer
ConnectUPS
Web/SNMP Card
Serial Cable
Figure 4. Cable Connection from Serial Port
.