Filter
Top Products
Remote Configuration
ConnectUPS Web/SNMP Card (X and BD Models) User’s Guide : Rev A www.powerware.com
20
3. Select and edit the ConnectUPS Web/SNMP Card IP
Address
.
4. Select and edit the
Gateway Address for the network.
5. Select and edit the
Subnet Mask of the network.
6. Select
Set Values to save the new settings.
NOTE If you changed the IP address in Step 3, you must restart the
browser using the new IP address (see page 18) to restore communication
with the ConnectUPS Web/SNMP Card. Repeat Steps 1 and 2 to continue
the configuration.
7. Select Date and Time from the menu at the top of the
page.
8. Enter the appropriate date and time information in
the specified format.
9. Select
Set Values to save the date and time settings.
The ConnectUPS Web/SNMP Card is now configured for
operation on your network. Refer to the remainder of this
user’s guide and the online help for detailed information about
each menu selection.