Princeton 4411-0143 Webcam User Manual


 
34 IsoPlane
®
SCT 320 Manual Version 1.B
3.5 WinSpec
Start WinSpec after making sure the detector and IsoPlane are connected to the computer and are
turned on. WinSpec should find the detector and present a dialog for selecting the detector for
your experiment. Before you can use the IsoPlane, you must tell WinSpec that it is the
spectrograph you will be using.
3.5.1 Select the Detector
Note: If the detector is LN-cooled, the Dewar should be filled while the detector is ON.
1. If this is the first time you have installed WinSpec/32 and a supported detector, the Camera
Detection wizard will run automatically. Otherwise, if you installing a new detector type, click on
the Launch Camera Detection Wizard… button on the Controller/CCD tab to start the wizard.
2. On the Welcome dialog (Figure 3-5), leave the checkbox unselected and click on Next.
Figure 3-5. Camera Detection Wizard - Welcome dialog
3. Follow the instructions on the dialogs to perform the initial hardware setup: this wizard enters
default parameters on the Hardware Setup dialog tabs and gives you an opportunity to
acquire a test image to confirm the system is working.
4. If the detector is LN-cooled, fill the Dewar while the detector is powered ON.
3.5.2 Define the Spectrograph
1. From the Main menu bar, open the Spectrograph menu, and select Define.
Figure 3-6. Define Spectrograph dialog