iv IsoPlane
®
SCT 320 Manual Version 1.B
Appendix A Using the Monochromator Control Software .................. 39
A.1 Introduction .................................................................................................................... 39
A.2 Install the Monochromator Control Software ................................................................ 39
A.2.1 Monochromator Control Application Software ................................................. 39
A.3 Connecting the IsoPlane to the Computer ..................................................................... 39
A.4 Controlling the IsoPlane Spectrograph at the Command Level .................................... 39
A.4.1 Spectrograph Wavelength Movement Commands ............................................ 40
A.4.2 Grating Control Commands ............................................................................... 41
A.4.3 Slit Width Control Commands (for Motorized Slits only) ................................ 42
A.4.4 Additional Commands ....................................................................................... 42
Appendix B Spectrograph to Computer Cable Connection ............... 43
Appendix C Accessories Listing .......................................................... 45
Appendix D Gratings for IsoPlane ........................................................ 49
Appendix E Outline Drawings ............................................................... 51
Appendix F Standard Slit Assembly Drawing ..................................... 53
Appendix G Declaration of Conformity ................................................ 55
Appendix H Certification and Warranty................................................ 57
Index ....................................................................................................... 59
Figures
Figure 1-1. Light Path within the IsoPlane SCT 320 ......................................................................7
Figure 2-1. Details of the RS-232, USB, and Power Connections on the IsoPlane......................10
Figure 2-2. Power Supply .............................................................................................................11
Figure 2-3. Turret Compartment Location....................................................................................12
Figure 2-4. Center Torque Screw ..................................................................................................13
Figure 2-5. Location of Hole on Turret Grating Assembly ..........................................................13
Figure 2-6. Location of Post on Grating Spindle Assembly .........................................................14
Figure 2-7. Lower Turret into the Turret Compartment ...............................................................14
Figure 2-8. Turret Installed (Hole and Post Aligned) ...................................................................14
Figure 2-9. Mounting Plate ...........................................................................................................15
Figure 2-10. Micrometer Compartment Location .........................................................................18
Figure 2-11. Micrometer Locking Set Screw ...............................................................................18
Figure 2-12. Height Adjustment Screws .......................................................................................19
Figure 2-13. Slit Width Setting: 200 Micrometers (0.200 mm) ...................................................21
Figure 2-14. Slit Width Setting: 1380 Micrometers (1.38 mm) ...................................................21
Figure 2-15. Center Torque Screw ................................................................................................24
Figure 2-16. Lift Turret up out of the Turret Compartment .........................................................25
Figure 2-17. Center Torque Screw ................................................................................................26