Filter
Top Products
150
Using the Command Line Interface (CLI)
Set the Multicast Rate (802.11b Only)
[Device-Name]>set wif <index> multrate <1,2,5.5,11 (Mbits/sec)>
NOTE
The Distance Between APs must be set before the Multicast Rate.
Enable/Disable Super Mode (802.11a/g only)
[Device-Name]>set wif 3 super <enable/disable>
Enable/Disable Turbo Mode (802.11a/g only)
[Device-Name]>set wif 3 turbo <enable/disable>
NOTE
Super mode must be enabled on the interface before Turbo mode can be enabled.
Set Ethernet Speed and Transmission Mode
[Device-Name]>set etherspeed <value (see below)>
[Device-Name]>reboot 0
Set Interface Management Services
Edit Management IP Access Table
[Device-Name]>set mgmtipaccesstbl <index> ipaddr <IP address> ipmask <subnet mask>
Configure Management Ports
[Device-Name]>set snmpifbitmask <(see below)>
[Device-Name]>set httpifbitmask <(see below)>
[Device-Name]>set telifbitmask <(see below)>
Choose from the following values:
Set Communication Ports
[Device-Name]>set httpport <HTTP port number (default is 80)>
[Device-Name]>set telport <Telnet port number (default is 23)>
Ethernet Speed and Transmission Mode Value
10 Mbits/sec - half duplex 10halfduplex
10 Mbits/sec - full duplex 10fullduplex
10 Mbits/sec - auto duplex 10autoduplex
100 Mbits/sec - half duplex 100halfduplex
100 Mbits/sec - full duplex 100fullduplex
Auto Speed - half duplex autohalfduplex
Auto Speed - auto duplex autoautoduplex (default)
Interface bitmask Description
0 or 2 = disable (all interfaces) All management channels disabled
1 or 3 = Ethernet only Ethernet only enabled
4 or 6 = Wireless A only Wireless A only enabled
8 or 10 = Wireless B only Wireless B only enabled
12 = Wireless A and Wireless B Wireless A and Wireless B enabled
13 or 15 = all interfaces All management channels enabled