Filter
Top Products
22
Getting Started
5 GHz or AP-2000 11a Upgrade Kit
If you are installing this kit on a new AP (one that has not been installed yet), skip to Step 4.
1. Remove the AP from your network by unplugging the power and Ethernet cables from the unit.
2. Remove the unit from its mounting location - keep the mounting bracket with the AP.
3. Remove the outer plastic cover.
Figure 2-10 Remove the AP cover
NOTE
The AP-2000 Upgrade Kit may be installed only in slot A of the AP-2000.
4. Make sure card slot A is available. The power or Ethernet cable tie wrap may need to be cut and the cable
repositioned to allow the antenna adapter to fit correctly.
5. Position the antenna adapter, card inward, facing the top of the unit (see diagram) and insert the 5 GHz card into
the available card slot.
Figure 2-11 Insert Card and Antenna