Filter
Top Products
160
Using the Command Line Interface (CLI)
DHCP Server Parameters
NOTE
The DHCP Server (dhcpstatus) can only be enabled after a DHCP IP Pool table entry has been created.
DHCP Server table for IP pools
NOTE
Set either End IP Address or Width (but not both) when creating an IP address pool.
Name Type Values Access CLI Parameter
DHCP Server Group N/A R dhcp
DHCP Server Status Integer enable (1) (default)
disable (2)
delete (3)
RW dhcpstatus
Gateway IP Address IpAddress User Defined RW dhcpgw
Primary DNS IP Address IpAddress User Defined RW dhcppridnsipaddr
Secondary DNS IP
Address
IpAddress User Defined RW dhcpsecdnsipaddr
Number of IP Pool Table
Entries
Integer32 N/A R dhcpippooltblent
Name Type Values Access CLI Parameter
DHCP Server IP Address
Pool Table
Table N/A R dhcpippooltbl
Table Index Integer User Defined N/A index
Start IP Address IpAddress User Defined RW startipaddr
End IP Address IpAddress User Defined RW endipaddr
Width Integer User Defined RW width
Default Lease Time
(optional)
Integer32 3600-
86400 sec (default)
RW defleasetm
Maximum Lease Time
(optional)
Integer32 3600-
86400 sec (default)
RW maxleasetm
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable (1)
disable (2)
delete (3)
RW status