Filter
Top Products
178
Using the Command Line Interface (CLI)
Configuring a Security Profile with WPA-PSK Security Mode
set secprofiletbl <index> secmode wpa-psk passphrase <value> status enable
Example: set secprofiletbl 6 secmode wpa-psk passphrase 12345678 status enable
Configuring a Security Profile with 802.11i Security Mode
set secprofiletbl <index> secmode 802.11i rekeyint <value> status enable
Example: set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable
Configuring a Security Profile with 802.11i-PSK Security Mode
set secprofiletbl <index> secmode 802.11i-psk passphrase <value> status enable
Example: set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable
Other Parameters
IAPP Parameters
NOTE
These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
SpectraLink VoIP Parameters (802.11b and bg Modes Only)
These parameters enable or disable the SpectraLink Voice over IP feature.
The Spectralink Legacy Support parameter should be enabled if the AP is operating in 802.11bg mode and legacy
802.11 Spectralink telephones are used. This parameter will set the basic rates of the AP to be 1 and 2 Mbps in
802.11bg mode and will allow old telephones that operate only at the 1 and 2 Mbps basic rate to connect to the AP.
Name Type Values Access CLI Parameter
IAPP Group N/A R iapp
IAPP Status Integer enable (default)
disable
RW iappstatus
Periodic Announce
Interval (seconds)
Integer 80
120 (default)
160
200
RW iappannint
Announce Response
Time
Integer 2 seconds R iappannresp
Handover Time-out Integer 410 ms
512 ms (default)
614 ms
717 ms
819 ms
RW iapphandtout
Max. Handover
Retransmissions
Integer 1 - 4 (default 4) RW iapphandretx
Send Announce
Request on Startup
Integer enable (default)
disable
RW iappannreqstart
Name Type Values Access CLI Parameter
Spectralink VoIP Group N/A R spectralink
Spectralink VoIP Status Integer enable
disable (default)
RW speclinkstatus
Spectralink Legacy
Support
Integer enable
disable (default)
RW speclinklegacysupport