Q-Logic ISR6152 Network Router User Manual


 
B–Log Messages
ISR645610-00 B B-21
107041 #%d: QLUpdateDeviceDatabase 0x%x: GET_ID
failed %x
FC Error Driver’s host (initiator) database is full. Maximum
host database is 64.
107056 #%d: QLUpdateDeviceDatabase 0x%x: out of
slots in host database
FC Error Drivers host (initiator) database is full.
107078 #%d: QLUpdatePort 0x%x: out of slots in
host database
FC Error Driver was unable to re-establish connection to the
target within the timeout and retry counts, and is
therefore marking it offline.
107984 #%d: QLWriteFlashDword: Write fails at
addr 0x%x data 0x%x
FC Error Fibre Channel controller failed a Flash write (address
x data x).
108032 #%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for VP %d fatal
error
FC Error Fibre Channel controller failed the Get VP Database
command (for virtual port %d).
108033 #%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for VP %d failed
%x
FC Error Fibre Channel controller failed the Get VP Database
command (for virtual port %d) with status x.
108049 #%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB failed MB0 %x MB1 %x
FC Error Fibre Channel controller reported failure status for an
Execute IOCB (input/output control block) command.
108050 #%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB fatal error
FC Error Fibre Channel controller reported a fatal error while
processing an Execute IOCB command.
108064 #%d: QLGetFwState: Get Firmware State
failed 0-3 %x %x %x %x
FC Error Fibre Channel controller reported failure status for a
Get Firmware State command.
118882 #%d: QLIoctlDisable: Reset adapter FC Info Request to reset the Fibre Channel processor
(adapter) received from IOCTL interface.
Table B-1. iSR6152 Router Log Messages (Continued)
ID Log Message
Module
Type
Msg.
Type
Description