Filter
Top Products
A–Simple Network Management Protocol (SNMP)
Management Information Base (MIB)
A-2 ISR645610-00 B
SNMP Trap Configuration
SNMP trap configuration supports setting up to eight trap destinations. Choose
from Traps 1 through 8 to configure each trap. Table A-2 describes the
parameters for configuring an SNMP trap.
Management Information Base (MIB)
The following sections describe the QLogic management information base (MIB).
The MIB consists of four object groups:
“System Information” on page A-3
“Network Port Table” on page A-4
“Fibre Channel Port Table” on page A-6
“Sensor Table” on page A-8
System contact Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters excluding
the number sign (#), semicolon (;), and comma (,). The default
is undefined.
Authentication traps Enables or disables authentication trap generation in response
to authentication failures. The default is disabled.
Table A-2. SNMP Trap Configuration Parameters
Parameter Description
Trap n enabled Enables or disables trap n. If disabled, the trap is not configured.
Trap address
a
a
Traps (other than 0.0.0.0) and trap port combinations must be unique. For example, if trap 1 and
trap 2 have the same address they must have different port values. Similarly, if trap 1 and trap 2
have the same port value, they must have different addresses.
Specifies the IP to which the SNMP traps are sent. A maximum of
eight trap addresses is supported. The default for traps is 0.0.0.0.
Trap port
a
The port number on which the trap is sent. The default is 162.
Trap version Specifies the SNMP version (1 or 2) with which to format traps.
Table A-1. SNMP Properties (Continued)
Parameter Description