Filter
Top Products
Manual for PlatiniX 2 series
Overclocking Jumper Setting (JFS1)(optional)
Jumper JFS1 provides users with CPU overclocking feature. The host bus speed can be
set as 100x4/133x4MHz or AUTO. If CPU FSB is set as Auto, the system detects the CPU
FSB (front side bus) automatically. The table below is for your reference.
Whether or not your system can be overclocked depends on your processor’s capability.
Whether the processor is bus ratio locked or unlocked should also be taken into account.
For bus ratio unlocked processor, this overclocking feature can be implemented by setting
CPU FSB as 100x4/133x4MHz, meanwhile adjusting the bus ratio (multiplier) in “CPU
SpeedEasy Setup” in AWARD BIOS CMOS Setup.
You can also adjust the CPU frequency by running StepEasy(optional). We do not guaran-
tee the overclocking system will be stable.
Warning: Be sure your selection is right. CPU over speed will be dangerous! We
will not be responsible for any damages caused.
“1-2”: pin1 & pin2 closed
“2-3”: pin2 & pin3 closed
JFS1
123
Chapter 2
CPU FSB AUTO 100x4MHz 133x4MHz
JFS1 1-2 2-3 OPEN
(default)