Filter
Top Products
Manual for PlatiniX 2 series
F5:
a. When two or more than two hard disks are installed on the system, use F5
key to choose the hard disk. Every time users use F5 key to switch the hard
disk, the operation result for the previous hard disk is saved. When processing
a certain hard disk, F5 key can be used to choose the partition.
b. In addition, when two or more than two hard disks are installed, the sign of
partitions will be changed from C, D, E, F to 1, 2, 3, 4 accordingly.
2. Recovery Interface (see figure-3)
Users can backup the partition to its mirror area, and recover the partition from its
mirror area from Recovery User Interface. This interface also provides users with
CMOS settings backup or recovery, and changing password functions.
2.1 BACKUP PAR
Function : Backups the content of the partition to its mirror area.
Limitation: If no mirror partition exists, this button is disabled.
Steps:
a. Use F5 key to choose the partition with mirror area existed.
b. If the partition chosen has been backuped before, a warning message will be
shown, and the time when last backup was done will be displayed in the status line.
After confirming the warning message, the system performs the backup. By press-
ing “N” or “ESC” key, the system quits.
2.2 RE-CVR PAR
Function : Recovers the content from the mirror area to the relate partition.
Limitation: If users didn’t backup any partitions before, this button is disabled.
Steps:
a. Use F5 key to choose the backuped partition.
b. The time when the latest backup was done will be displayed in the status line.
After confirming the warning message, the system performs the content
recovery. By pressing “N” or “ESC” key, the system quits.
figure-3 Recovery User Interface
Appendix