Manual for PlatiniX 2 series
Enable keyboard password power-on function (JKB)
The mainboard provides the advanced keyboard password power-on function. Before
using this function, set JKB with pin1 & pin2 closed. Otherwise, set JKB with pin2 & pin3
closed for disabling.
Furthermore in order to implement this function, set “POWER ON Function” to Password
and enter the keyboard power-on password in the “INTEGRATED PERIPHERALS” section
of the CMOS SETUP. Save and exit, then power off your system. In this case, the power
button’s power-on function has been disabled.
Note:
1. If using this function, 5VSB line of the power supply should be capable of
delivering enough current for all the devices connected to the keyboard port,
if not, you will be unable to power up the system using the keyboard.
2. If you set JKB with pin2 & pin3 closed, set “POWER ON Function” to BUTTON
ONLY, don’t set it to Password, or you’ll be unable to power up your system
by the keyboard or the power button.
3. If you encounter the above problems, clear CMOS and set the jumper and
BIOS option again.
JKB
JKB
1
2
3
1
2
3
Disable
Enable
(default)
Chapter 2