Filter
Top Products
AirborneDirect™ Users Guide Quatech, Inc.
100-8510-110 2/21/2011 35
12.0 Configuring Device – Industrial Serial (ABDG-SE-IN5XXX)
The following describes initial connection to an AirborneDirect™ Serial Device Server
(ABDG-SE-IN5XXX). If you have an Ethernet device (ABGD-ET-DP5XX/IN5010), please
go to section 14.0. If you have purchased a SE-DP5XX device please go to section 13.0
for the set-up instructions.
The instructions in Table 14 provide step-by-step instructions for configuration of the
ABDG-SE-IN5XXX product family.
Table 14 - SE-IN5XXX Accessing the Web Interface
1
Open the AirborneDirect™ packaging and locate the Install CD.
2
Place the CD in the CD/DVD drive of the laptop or desktop you will be using to configure the
AirborneDirect™ device. Follow the on screen directions for installation of the appropriate device
software and documentation.
3
Connect the Ethernet cable on ABDG to an Ethernet port on the laptop or desktop system.
4
Apply power to the ABDG-SE-IN5XXX.
5
The unit will boot and display one of the following LED patterns:
ABDG-SE-IN5XXX
COMM: Off
LINK : Off
POST: Orange
POWER: Blue
6
Run the Airborne Management System application. This was installed during the CD installation and a
menu item will be found in the Airborne folder located in the programs directory of your system.
When the application opens the following dialog will be displayed:
Select Group Name: manuf and enter Group Password: dpac