Filter
Top Products
Quatech, Inc. AirborneDirect™ User Manual
38 2/21/2011 100-8510-110
13.0 Configuring Device – Enterprise Serial (ABDG-SE-DP5XX)
The ABDG-SE-DP5XX family does not have an Ethernet port for initial configuration so
initial configuration can be performed through the serial port. To do this it is necessary to
connect using the serial connector.
13.1 Connect a Host Computer
Connect the serial pigtail connector to the serial port on a host computer.
It may be necessary to use a gender changed that includes a Null Modem adapter.
13.2 Interacting with the AirborneDirect™ device
On the Host computer, use a terminal emulation program to interact with the
device issuing Quatech Command Line Interface (CLI) commands. CLI
commands let you request status or change parameter settings. Press the Enter
key (<CR>) after each command line you type. After the module starts, type the
following CLI command to log in (you must log in before CLI commands can be
recognized):
Table 15 - UART Authentication
CLI Command
Description
Send Break Sequence
The serial port starts up in a listen mode waiting for a
request for a data tunnel. To access the CLI mode in
which set-up can take place the break sequence must be
sent.
The default break sequence for the device is ÿ~ABD
The sequence must be sent with no trailing characters.
If received correctly the device will respond OK.
auth dpac dpac <CR>
The module responds with OK, indicating that it
executed the command successfully. (If you did not
receive OK, check the settings in your terminal emulation
program).
You will have to break into CLI mode and log into the module after any reset or
restart.