Filter
Top Products
Quatech, Inc. AirborneDirect™ User Manual
80 2/21/2011 100-8510-110
Step
Description
Feature Link
Select Connection Settings
The target device configuration must be configured to
make sure the master device connects to the correct
slave.
A page showing the configuration options for TCP/IP
and UDP connections to and from the device.
Configuration of Telnet, HTTP and SSH ports is
possible through this page.
Select TCP Port
This is the target port for the TCP connection on the
slave device. This should be set to the listen port
assigned during the configuration of the slave. The
default for the listen port is 8023.
Select TCP Timeout
This parameter allows the device to close the TCP
socket to the slave should the connection be lost. The
default of 0 disables the timeout.
The timeout setting should be based upon the period
of time a connection would not be used. It should at
least exceed the worst case of the data period.
Select Primary TCP Target Server IP Address
Enter the static IP address that was given to the slave
device during configuration.
Select Outbound Transmit Type
This is the outbound transmission protocol.
Set this to TCP from the drop down list.
Press Commit [Button]
Saves changes to the device.
Press Reload [Button]
Reloads the WLAN Settings page.
Optional
Press Reload [Button]
Reloads the Serial Port Settings page. Select this is
you have further configuration options to change.
Optional
Press Restart [Button]
Restarts the device. After the device as rebooted it will
create an AdHoc network with the name you gave the
SSID. As long as the network is in range the wireless
interface will connect.