Filter
Top Products
55
Trunking Operation
Storing Talk Group IDs
To store a talk group ID when scanning, press
TRUNK
when the scanner stops on a transmission. The bottom
line changes to
ID#XXXX
, indicating that the ID is
stored.
Note:
When you try to store more than 100 talk group
IDs in a bank,
Memory full!
appears. Clear some
talk group IDs in order to store new ones (see “Clearing
Talk Group IDs” on Page 56).
Follow these steps to manually store talk group IDs or to
edit a stored ID.
1. Press
PGM
.
2. Press
TRUNK
.
3. To select the bank where you want to store the ID,
press
FUNC
then or .
4. Press
MODE
to select
LT
,
MO
, or
ED
.
5. Enter the talk group ID and press
ENTER
. If neces-
sary, use the decimal point for a hyphen.
Note:
If you made a mistake in Step 4,
Invalid
ID
. appears and the scanner beeps when you
press
ENTER
. Start again at Step 3.
6. Press
TEXT
and enter the text tag for the ID, then
press
ENTER
.
7. To store the next ID memory in sequence, press
and repeat Steps 4 and 5 to enter more IDs.
8. Press
SCAN
to start scanning.
Talk Group ID Hold
You can set your scanner to follow a trunking signal that
you want to track during scanning.
Hold down
TRUNK
for
more than 2 seconds.
ID
hold
ON.
appears.
To release ID hold, press
SCAN
or
TRUNK
.
20-522b.fm Page 55 Thursday, September 7, 2000 9:41 AM