Filter
Top Products
31
Operation
Notes:
• If you made a mistake in Step 3,
Invalid
Freq
briefly appears and the scanner beeps
when you press
ENTER
. Start again from Step 3.
• Your scanner automatically rounds the entered
frequency to the nearest valid frequency. For
example, if you enter a frequency of 151.473,
your scanner accepts it as 151.470.
•Press
FUNC
then
DELAY/1
to turn the delay func-
tion on or off. To have the scanner pause for 2
seconds on this channel after a transmission
before proceeding to the next active transmis-
sion, see “Using the Delay Function” on Page 40.
The scanner stores this setting in the channel.
• If you are storing frequencies for an EDACS sys-
tem, you must store them in logical channel num-
ber order, with the first frequency in channel 1 for
the current bank.
5. If necessary, press
MODE
to change the receiving
mode. If you select
P/L
or
DPL
, enter the PL or
DPL code by pressing
STEP
(to move up through
the codes) or
FUNC
then
STEP
(to move down
through the codes).
6. If desired, program a text tag for the channel (see
“Assigning a Text Tag to a Channel”).
7. The next channel in sequence is ready for program-
ming. Press
PGM
and then repeat Steps 3 through
5.
STORING TEXT TAGS
You can customize your scanner by storing text tags (up
to 12 characters) for easy identification of channel trans-
missions, trunk IDs, or banks.
Assigning a Text Tag to a Channel
1. Press
MANUAL
, enter the channel number where
you want to enter the text, then press
MANUAL
again.
M
and the channel number appear at the
upper left corner of the display (for example:
M100
).
20-522b.fm Page 31 Thursday, September 7, 2000 9:41 AM