Filter
Top Products
38
Operation
Note:
You must store frequencies into channels before
the scanner can scan them. The scanner does not scan
empty channels.
The scanner scans through all channels (except those
you have locked out) in the active banks (see “Turning
Channel-Storage Banks Off and On” and “Locking Out
Channels or Frequencies” on Page 41).
Turning Channel-Storage Banks Off and
On
To turn off banks while scanning, press the bank’s num-
ber key until the bank’s number disappears. The scan-
ner does not scan any of the channels within the banks
you have turned off.
Notes:
• You cannot turn off all banks. There must be at least
one active bank.
• You can manually select any channel in a bank,
even if the bank is turned off.
To turn on banks while scanning, press the number key
until the bank’s number appears.
MANUALLY TUNING A FREQUENCY
1. Press
TUNE
.
2. Use the number keys to enter the frequency.
3. Press
ENTER
.
4. Press to move up one tuning step. Press to
move down one tuning step. To move up or down in
1 MHz increments, press
FUNC
then or for
each increment.
To save the frequency into a channel (bank 9 only),
press
FUNC
then
ENTER
.
Stored
@
9xx
appears
(
xx
is the channel number).
When the scanner stops on a frequency while searching,
press
FUNC
then
TUNE
.
20-522b.fm Page 38 Thursday, September 7, 2000 9:41 AM