Renesas 6NM Laptop User Manual


 
Rev.1.10 Jul 01, 2005 page 298 of 318
REJ09B0124-0110
M16C/6N Group (M16C/6NK, M16C/6NM) 22. Usage Precaution
Under development
This document is under development and its contents are subject to change.
22.11.2 Special Modes
22.11.2.1 Special Mode 1 (I
2
C Mode)
When generating start, stop and restart conditions, set the STSPSEL bit in the UiSMR4 register to 0
(start and stop conditions not output) and wait for more than half cycle of the transfer clock before setting
each condition generate bit (STAREQ, RSTAREQ and STPREQ bits) from 0 (clear) to 1 (start).
22.11.2.2 Special Mode 2
_______
If a low-level signal is applied to the NMI pin when the IVPCR1 bit in the TB2SC register = 1 (three-phase
_______ _________
output forcible cutoff by input on NMI pin enabled), the RTS2 and CLK2 pins go to a high-impedance state.
22.11.2.3 Special Mode 4 (SIM Mode)
A transmit interrupt request is generated by setting the U2IRS bit in the U2C1 register to 1 (transmission
complete) and U2ERE bit in the U2C1 register to 1 (error signal output) after reset. Therefore, when
using SIM mode, be sure to set the IR bit to 0 (no interrupt request) after setting these bits.